|
Post by intersimi on Jan 24, 2006 10:46:44 GMT
I have started making a 3D model of a Tardis and would like to keep the 3D design as close as I can to what I would use in real life.
The issue I have is the corners of the Tardis, the posts. They seem non square to me. Any hints and tips on how to put this together (with wood)?
|
|
|
Post by Will Small (Tardis Builder) on Jan 28, 2006 21:23:49 GMT
The corner posts are not easy. I can tell you that they are square. But the post are double layered. To make them you need two long lengths of equal size, one length is say 1.5cms wide and the other is 1cm wide. Stick the shorter length side on to the flat surface of the wider one and allow to fully dry. You will then have 2 sides of a corner post equal width and length. Then once stuck together you need to stick on top two smaller bits of wood. These top pieces are the same length but the width's are smaller then the lengths you just completed. This gives the illusion of double layered thick corner posts. Hope this helps
|
|